Modeling of Mechanisms and Robotic Manipulators Taking into Account Distributed Inertia of Motion

Yerbol Temirbekov1,2

Muratulla Utenov1,2

Seitbek Zhunisbekov3

Algazy Zhauyt4

Saltanat Zhilkibayeva5

Bairon Karassayev2, Email

1Institute of Mechanics and Engineering named after U.A. Dzholdasbekov, Almaty, 050010, Kazakhstan
2Department of Mechanics, Al-Farabi Kazakh National University, Almaty, 050013, Kazakhstan
3Department of Civil Engineering and Building Materials, Satbayev University, Almaty, 050013, Kazakhstan
4Department of Aerospace and Electronic Engineering, Almaty University of Power Engineering and Telecommunications named after G. Daukeyev, Almaty, 050013, Kazakhstan
5Department of Mechanics and Engineering, M. Auezov South Kazakhstan University, Shymkent, Turkistan, 160012, Kazakhstan

 

Abstract

Strength and stiffness assessment of rod mechanisms and robotic manipulators is commonly performed using finite element methods (FEM), while motion-induced inertia is often represented by resultant forces and moments applied at link centers of mass. This simplification is inherently approximate because inertial and gravitational forces are distributed along the link and depend on instantaneous kinematics. The main contribution of this paper is a systematic FEM-ready algorithm that extends a previously planar distributed-inertia concept to a formulation applicable to both planar and spatial rod models. The proposed approach computes distributed inertial and weight load intensities in the local coordinate system of each moving rod from kinematic quantities (link orientation, angular velocity/acceleration, and pole accelerations), transforms them into consistent equivalent nodal forces and moments, and assembles them into the global FEM equilibrium system for strength and stiffness calculations. Unlike flexible multibody dynamics formulations (e.g., floating frame of reference formulation (FFRF)/ANCF) absolute nodal coordinate formulation, which primarily target time-domain dynamic simulation, the proposed method is design-oriented and directly produces configuration-dependent engineering outputs-bending moments, axial forces, and longitudinal/transverse displacements-required for link cross-section sizing and stress assessment. The method is demonstrated on a six-bar planar mechanism to illustrate the influence of distributed inertia on internal force and deformation diagrams at low and high driving speeds.

Modeling of Mechanisms and Robotic Manipulators Taking into Account Distributed Inertia of Motion